Assembly Part-1

1.  First check your kit to make sure the contents are all there:

Fig 1:  Main kit contents, plus some of the other required items:

2.  Fuselage and Tail Panels

You can safely ignore the manual, where it recommends cutting the control snakes and tubes, as it seems this was already done, at least in our kit.  Next we install the Elevator and Rudder tubes (sleeves).  Make sure these are glued along their full length to give stiffness to the aircraft.  Then feed the control rods through the tubes.  **Note that we don't connect the control rods to any of their surfaces, simply get them close for now, as we cant set the "center position" with battery and TX turned on just yet (last few steps).  Note the basic positioning of the ends of each rod/sleeve in Fig. 2

Figure2:

Next... Installation of the wing mounts in Assembly Part-2